Delta AR 15 takedown Pin Set (4-6 week delivery)

$79.99

The Delta AR 15 takedown pins are designed to remove all movement from the mating of the upper and lower receiver in the AR platform. If the AR 15 you have uses the standard takedown pins, then this set is a must need to correct the inherent movement with your rifle. Regardless of caliber, the AR 15 pins are standard which means these will fit all the AR 15 platforms.

NOTE: These pins are NOT COMPATIBLE with the AR-10 Receivers!

Available on backorder

SKU: d14ctdp Categories: ,

Description

The Problem:

Upper and lower AR 15 platform movement.

If you grab the upper receiver with one hand and the lower with the other, you will find there is a movement (“Battle Rattle”) that can be found. This tolerance is something the best manufacturing process cannot remove. This movement directly impacts the accuracy of your rifle and accounts for a large percentage of shot-to-shot variances.

 

The Solution:

The Delta AR 15 takedown pins are designed to remove all movement from the mating of the upper and lower receiver in the AR platform. If the AR 15 you have uses the standard takedown pins, then this set is a must need to correct the inherent movement with your rifle. Regardless of caliber, the AR 15 pins are standard which means these will fit all the AR 15 platforms.

NOTE: These pins are NOT COMPATIBLE with the AR-10 Receivers. The pins are a different size which the Delta AR 15 takedown pin set is not compatible with.

 

Information:

No tools are needed to install these pins. As with old military rifles, you only needed a spent cartridge to field strip your weapon. Delta 14 Inc. is astute to history and looked to bring this concept back to life. The screw used to apply the pressure in the Delta AR 15 takedown pin uses the negative head of the rim of a 556 cartridge. This means your 1 spent round just became your screwdriver. Yes, you can use a flat-head screwdriver as well but to limit the tools needed this design promotes ease of use. Please be advised to use a spent cartridge and not a live round. Additionally, the current detents used to hold the takedown pins are not needed. When you remove the existing takedown pins you can remove the springs and detents for them. The pin locks in place and through rigorous testing will not vibrate out using the proper torque on the fastener.

 

Attributes:

Precision made from 303 stainless steel for long life and durability

Eliminates all “Battle Rattle” caused by the clearance between the upper and lower receivers

Improves accuracy

Specialty designed screw allows for removal with Common Screwdriver or 5.56mm casing. No special tools required

Make in USA (Rochester Hills, Michigan)

Guaranteed for life

Please allow 6–8-week delivery time due to production congestion.